MF PROJECTS HOME TECHNICAL TIPS MOBILE SITE
PIC Projects
WiFi - ESP8266
Doorbell with SD / EEPROM
SD FAT16/32 for .bmp
TFT Egg Timer
LCD TFT Oscilloscope
SD Talking Clock
SD Sound Recorder,
    FAT32 wav Player
LED Thermometer
LED Egg Timer
LCD Egg Timer

Frequency Counters
TFT 10MHz
100KHz For PC
1MHz For PC
8 Digits LED 50 MHz
Scope Screen Display
LCD Module 10MHz
6MHz for Android
USB PIC18F2550
USB TFT display BMP
USB DS18B20 Sensor
USB Thermometer
USB Counter
USB Meter
USB Oscilloscope
USB Input-Output
USB 16x2 LCD

COM & LPT Ports
MCP3201 on LPT
Serial TFT Text
Serial Inputs Outputs
Serial Port LCD
Analogue Signal to LPT
MCP3201 on Serial Port
Serial Thermometer
Analogue Signal to Serial
LCD Display on LPT
Serial Thermostat

Others
Water Softener
HP Stream 7 docking
3.7V to 5V
Solar Charger

Infrared Decoder
PIC Music

Code Lock
Code Lock with LCD

SELF POWERED ADC INTERFACE TO PARALLEL PORT

Project for connecting analogue signal to LPT printer port. Included Visual Basic 6 software and a circuit diagram. The MCP3201 is a micro-power 12 bit analogue to digital converter. The conversion selector selects the MSB when it sets to 8 Bit or 10 Bit and ignores the rest of the bits. With less resolution the reading is more stable. The supply to the circuit is via the 5V at pins that are switched to logic high by the software.
The VB6 software includes a freeware DLL from http://logix4u.net/ ,keep the .dll file and the .exe file in the same folder.
Datasheet for the MCP3201 can be downloaded from http://ww1.microchip.com/downloads/en/DeviceDoc/21290D.pdf
VB6 code (30KB). You are free to use the circuit diagram and the VB software with no limitations.

The VB6 application is a combined digital and analogue voltmeter.

Circuit Description
See also Technical Tips

MCP3201
Input at pin 2 of the ADC is 0 to 2.5 volts full range positive voltage only. The chip over voltage protection is 5V max.
Pin 8 is the supply to the IC and it is about 3.2 V.
Pin 1 is reference voltage for the ADC and cannot be changed because it regulates the supply to the IC.
Pin 6 is the serial data out of the ADC, BC237 is a TTL level drive.
Pin 7 is the clock for reading the data, 100pF is for filtering crosstalk from the cable.
Pin 5 is the Chip Select.
100R resistors and diodes on these lines are for clipping the voltage to the Vcc of the IC.

LPT plug
Pins 23,34,25 are earth. Pins 1,11,14 are inputs and outputs used for reading the ADC data. Pins 8,9 are switched to 5 V ,output high, by the software and are used for powering the circuit.