MF PROJECTS HOME TECHNICAL TIPS MOBILE SITE
PIC Projects
WiFi, Ethernet
Doorbell with SD / EEPROM
SD FAT16/32 for .bmp
TFT Egg Timer
LCD TFT Oscilloscope
SD Talking Clock
SD Sound Recorder,
    FAT32 wav Player
LED Thermometer
LED Egg Timer
LCD Egg Timer

Frequency Counters
TFT 10MHz
100KHz For PC
1MHz For PC
8 Digits LED 50 MHz
Scope Screen Display
LCD Module 10MHz
6MHz for Android
USB PIC18F2550
USB TFT display BMP
USB DS18B20 Sensor
USB Thermometer
USB Counter
USB Meter
USB Oscilloscope
USB Input-Output
USB 16x2 LCD

COM & LPT Ports
MCP3201 on LPT
Serial TFT Text
Serial Inputs Outputs
Serial Port LCD
Analogue Signal to LPT
MCP3201 on Serial Port
Serial Thermometer
Analogue Signal to Serial
LCD Display on LPT
Serial Thermostat

Others
Water Softener
HP Stream 7 docking
3.7V to 5V
Solar Charger

Infrared Decoder
PIC Music

Code Lock
Code Lock with LCD

USB OSCILLOSCOPE

USB low frequency oscilloscope, bandwidth is DC to 1KHz. Max sampling rate is 12680 samples per second. The trigger circuit uses the integrated comparator and CCP. An oscilloscope with these specifications has limited use, but it has an advantage on analogue oscilloscope for low frequencies.
Included Visual Basic 6 software and a circuit diagram. The circuit is powered by the USB. The interface to the PC is HID class.
The screen is constructed from 64 sampling. The ADC reads the input at resolution of 8 bits and in intervals determent by the Time Base. The 64 bytes are transmitted in one stream every 100ms or longer for lower frequencies.
HID class (human interface device) is a USB class of devices like the mouse and the keyboard, the data transfer rate is limited to 64KB/S.
PIC18F2550 code is assembler code and C code (under GNU General Public License) for Microchip C18 compiler.
VB6 code includes guidance to setting up the PC. The PC register the PID (Product ID) and VID (Vendor ID) of the USB device when it's plugged, the VB code uses these ID's to communicate with the device. For commercial VID it is needed to buy it from USB-IF, but in your lab you can use any number.
The source code is derived from freeware from these sources: http://janaxelson.com/usb.htm , http://openprog.altervista.org/USB_firm_eng.html
Code was written on MPLAB 8x and compiled with C18 ver 3.30. PIC18F2550 was programmed using Velleman K8076.
Software includes PIC code and VB6 code. You are free to use the circuit diagram and the VB software with no limitations.

The VB6 application.

Circuit Description
See also Technical Tips

PIC18F2550
Pin 3 is the analogue input. Input voltage range is 0 to 5V absolute max, voltage outside this range can latch the input or even permanently damage the IC.
Pin 4 is the comparator input used to generate the trigger.
Pin 14 is 3.3V internal supply for the USB transceiver.
Pins 15,16 are the data lines to the USB connector on the PC.
Pin 20 is the PC 5V powering the PIC. It is limited to 100mA by the PC. 0.47uF is for decoupling.
For USB wiring info: http://www.interfacebus.com/Design_Connector_USB.html





Name:

Comments and questions

Copy the number from the picture It stops net-robots from adding comments.


Be the first to add a comment.